Printing Forum Posts

[APXG]

Is there an efficient way to do this? How can you make text smaller and occupy whole page instead of small column in the middle?

Thanks.

[fozzy71]

Copy/Paste into NotePad or MS Word, then print?

[APXG]

I meant if I want to print a 50 page thread. If I paste it into word, how do I remove all the garbage on the side?

[fozzy71]

By carefully draggin and selecting only the center information.

The Right Way





The Wrong Way





[b]MS Word - pasted properly. Paint works fine also.

[freecard4all]

Print Topic! FTW! [img]/images/graemlins/wink.gif[/img] (lower left corner)

It's not the best option but it works (I especially like 1-line posts that use third of the page because of picture and info about the poster). I sometimes copy&paste it into the word and cut-off the left column and then only guess who's reacting to whom. [img]/images/graemlins/cool.gif[/img]

[_dave_]

[ QUOTE ]
Print Topic! FTW! [img]/images/graemlins/wink.gif[/img] (lower left corner)

It's not the best option but it works (I especially like 1-line posts that use third of the page because of picture and info about the poster). I sometimes copy&paste it into the word and cut-off the left column and then only guess who's reacting to whom. [img]/images/graemlins/cool.gif[/img]

[/ QUOTE ]

lololol "type=thread" FTW !!!

I was gonna post about the little printer icons on each post, but I couldn't figure the url needed to get a whole thread, although I knew I'd seen it before [img]/images/graemlins/smile.gif[/img]

tytyty [img]/images/graemlins/smile.gif[/img]