[brettbrettr]

So, I did things backwards and bought clubs at the beginning of the summer, went for a fitting this am.

I was a bit concerned that this would be more sales pitch than fitting, seeing as how this joint is a "Callaway Performance Center." But, I'm only mildly concerned.

Overall, I was told that the clubs I have (PingG10, standard lie) are good for me, save that I would do well to have them adjusted 1 degree flatter. I was also told that Ping will do this for free!?!?!?!

He did also recommend the X20 irons, saying that the center of gravity in those was slightly higher than my clubs, and that I'd probably outgrow/play my irons within a year. I tend to hit the ball high, and he said my Pings are high ball clubs, etc. But during the fitting he gave me a grip and set-up tip which lowered my ball flight to just above the normal range, and added about 20 yards anyways. So, I gotta go work on that...

The other thing he mentioned is that my irons swing speed (78-82, 7iron) puts me right on the edge of a stiff or reg flex shaft. I have reg flex steel now, but he mentioned that the X20 come with a Uniflex R/S shaft which is right in between. Again, he said what I have is fine, but I could consider stiff flex shafts too. How would I decide here?

He approved of my woods, which is relieving (Callaway Xseries, stiff flex shafts).

Anyways, I DID NOT get all the data and take it home with me. I should have written it down, as I'm sure that would be much more helpful. Just wanted to throw this up there to get your guys' opinion.