Re: $50 on Full Tilt to Whoever solves this problem tonight
 

[ QUOTE ]
can nobody help figure out why the 2560 x 1600 is not properly scaled to my monitor?

[/ QUOTE ]
Sounds like your card is outputting the correct resolution but for some reason the monitor is in a lower resolution. What resolution does the monitor think its displaying when this happens?

Re: $50 on Full Tilt to Whoever solves this problem tonight
 

[ QUOTE ]
My Question - Why is Catalyst recognizing what should be the 3007 30" monitor as the 2007 22" monitor??


[/ QUOTE ]
Perhaps the wrong drivers are loaded for it?

Re: $50 on Full Tilt to Whoever solves this problem tonight
 

I'm not sure what you mean by "what doe sthe monitor think".

But when I turn the computer on with only the 30" connected to the card it sets the resolution at 1280 x 800...


I am 99% sure the drivers are correct as funkyworms helped me reinstall them

Re: $50 on Full Tilt to Whoever solves this problem tonight
 

[ QUOTE ]
I'm not sure what you mean by "what doe sthe monitor think".

But when I turn the computer on with only the 30" connected to the card it sets the resolution at 1280 x 800...


I am 99% sure the drivers are correct as funkyworms helped me reinstall them

[/ QUOTE ]
Most monitors have controls on them for adjusting the image position, colors, etc. They also typically will display the resolution information.

Re: $50 on Full Tilt to Whoever solves this problem tonight
 

the only controls I see on the 30" is a +/- sign which adjusts the brightness....

Re: $50 on Full Tilt to Whoever solves this problem tonight
 

Ok breakthrough I think,

I just started my computer with the 30" plugged into the PCIe DVI output as usual, and as usual, wrong res - it starts up defaulted to 1280 x 800. And the 20" hooked up to the VGA and working fine.

Then, once the computer is on and running, I try pluging the other 20" VGA into the PCIe and this 20" defaults to run at 2560 x 1600???

Everything is much smaller and shrunk down on the one 20" that is running at 2650 x 1500, I'm sure this info can be used to help solve the problem, i just don't know how....wtf?

Nevermind obv the 20" is running at 1600 x 1200.....

Re: $50 on Full Tilt to Whoever solves this problem tonight
 

[ QUOTE ]
[ QUOTE ]
My Question - Why is Catalyst recognizing what should be the 3007 30" monitor as the 2007 22" monitor??


[/ QUOTE ]
Perhaps the wrong drivers are loaded for it?

[/ QUOTE ]
I still think this is the most likely reason. Perhaps you associated the 3007 drivers with the wrong monitor? (I did this with my 204B)