[pistolero]

Question that may have been asked and answered somewhere, but I haven't found it.

When I run iWitness, it opens PP, starts searching for the limit I specified by scrolling down the list and attempts to open tables. Sometimes it stops on a table that qualifies according to the parameters I set up, but then skips it without opening it. I looked at the log file and it says that it "sent table #x", but the response is "checking table #y". This results in it scanning through the whole list of tables, but only opening a couple. It seems as though after it's found a couple of tables initially, it starts skipping the rest. I looked briefly at the code, but don't feel like interpreting the whole thing as I'm not up to speed on all of the AHK functions. Can someone tell me what's going on? TIA.